DA 120 EFI UAV Engine by HFE International comes complete with state of the art electronic fuel injection. The fuel injection provides operators the correct amount of fuel and spark advance during high performance flights.

Features a special magnet configuration mounted in the prop hub which allows for flipping of the prop for an easy start.

The ECM is powered by a single 3 cell Lipo battery of 1500mah or larger capacity. Total power draw is only 12 watts (1 amp) at full throttle.

The system is tested from sea level to 10,000 ft altitude and temperatures ranging from 10°F to 120°F.

Alternator System Options

Choose from the following alternator options, listed below. 

500W Starter Alternator

This 3 phase brushless alternator direct drives on the engine crankshaft. The stator mounts to the crankshaft casing, with the rotor spinning on the crankshaft.

The system can be paired with a 500 W Power Management Unit, with an integrated starter controller, allowing the engine to start remotely. The PMU provides three lines with a chosen voltage in the range: 24 – 28 VDC at 12.5A or 350W max, 12 – 15 VDC at 9A or 108W, and 4.8 – 8 VDC at 8A or 42W.

Configurable with LiIon, LiPo, LifePO4, SLA, NiCad, NiMH, and Lead Acid Battery.

 

Custom Alternators 

Custom options are available upon request.

Contact HFE International to discuss your setup. 

DA 120 EFI UAV Engine Downloads

DA 120 EFI Data Sheet

EFI Engine Owner’s Manual

DA 120 Supplemental Owner’s Document

About HFE International

HFE International develops and manufactures high end propulsion systems for UAV’s, drones, unmanned systems, and ground support equipment. These propulsion systems include fuel-injection and rotary systems with gasoline and multi/heavy fuel operation.

Founded in 2010, the company’s aim was to address the growing demand for reliable, small engines at an affordable price point. With over 1,000 units sold – at 25% the cost of the closest competitor – HFE engines are in use throughout the world including use by the US Armed Forces.